Operation of stud welding machine
Published:
Dec 19,2022
Place the stud welding machine in the workplace and ensure that the main power supply is turned off;
1、 Operating instructions for stud welding machine:
1. Place the stud welding machine in the workplace and ensure that the main power supply is turned off;
2. Connect the power cord to the 380V three-phase AC power circuit breaker. Note: The effective working voltage is 380V three-phase AC voltage, connect the phase line and ground wire, connect the welding torch cable to the power output connector, and be sure to tighten the cold pressed connector with a wrench;
3. Connect the welding grounding wire to the power output connector, and be sure to tighten the cold pressed connector with a wrench;
4. The welding grounding clamp clamps the workpiece at 180 degrees. It helps to prevent "arc blowing" during welding. Before installing the fixture, make sure that the contact surface of the workpiece is free of rust, paint and oil stains, otherwise the welding effect will be poor;
5. Connect the control cable of the welding gun to the socket of the power control line. Pay attention to the good contact between the plug and the socket at the end of the cable;
6. Select welding bolts whose diameter, length and material meet the requirements.
More news
Nantong Runwell Welding Machine CO.,Ltd.
Address：Building J6, East District, Qingfeng Pioneer Park, No. 1 Qingfeng Road, Chongchuan District, Nantong, Jiangsu, China.
Marketing Department：+86-513-83527313 +86-513-83549520
China World Trade Center Department：+86-513-83549521 +86-513-83518325
Service Department：+86-513-83549522 +86-513-83549523
E-mail：999@999welding.com
Fax：+86-513-83519614
Website
Copyright © 2022 Nantong Runwell Welding Machine CO.,Ltd.